Launch of the JK-BMS RS485 add-on for Home Assistant

[jlm]

Good afternoon Jean-Luc,
First off let me start by thanking you for all the effort.
I do however have a few questions in trying to get this going:
I cannot get it to use TCP, although gateway is working through other tests. What do I need to change for the USB, as one cannot remove the data there.
EDIT: Managed to get the TCP operational, from yaml editor changed usb descriptor to IP and port, thank you
Then I found the following:
I have a 15cell battery, so JK app reports 15 and all the rest fine.
But through the Add-on, it uses 16cell and thus work out the average and delta from that, so average gives 15 cell data plus 0 and divide by 16, and delta take the value between 0V and eg 3.5, and report delta as 3.5.
Thanks again and kind regards
Riaan

---

Bonsoir Riaan

Thank you for your encouragement.
Indeed, the USB port field is not taken into account when the IP gateway is enabled.
But I can't hide the field in the graphical configuration interface when the gateway is enabled.
Unfortunately, the controls are limited when it comes to managing these fields.
As I wrote to you on GitHub, I have taken note of your comment. 
Once the major development work has been completed, I will be able to focus on this,but for the moment it is not possible.
So, calculating averages using templates is indeed the solution.

See you soon.